HyperX Savage 16GB (2x8GB) Memory Kit 1866MHz DDR3 CL9 240-Pin DIMM 1.5V

… FBGA components per module. Each module kit supports Intel XMP
(Extreme Memory Profiles). Total kit capacity is 16GB. Each module has
been tested to run at DDR3-1866 at a low latency timing of 9-10-11 at
1.5V. The SPDs are programmed to JEDEC standard latency DDR3-1600 timing
of 11-11-11 at 1.5V. Each 240-pin DIMM uses gold contact fingers.

Features

JEDEC standard 1.5V (1.425V ~ 1.575V) Power Supply

VDDQ = 1.5V (1.425V ~ 1.575V)

800MHz fCK for 1600Mb/sec/pin

8 independent internal banks

Programmable CAS Latency: 11, 10, 9, 8, 7, 6

Programmable Additive Latency: 0, CL – 2, or CL – 1 clock

8-bit pre-fetch

Burst Length: 8 (Interleave without any limit, sequential with
starting address ‘000’ only), 4 with tCCD = 4 which does not allow
seamless read or write [either on the fly using A12 or MRS]

Bi-directional Differential Data Strobe

Internal (self) calibration : Internal self calibration through ZQ pin
(RZQ : 240 ohm ± 1%)

On Die Termination using ODT pin

Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C
TCASE 95°C

Asynchronous Reset

PCB: Height 1.18 inch (30mm), double sided component

Extra Info

Memory Size: 16384MB

Module Size: 8192MB

Memory Type: DDR3

Memory Package: DIMM

Designation: PC3-14900

Pin Configuration: 240 pins

Main Colour: Red